Measure this distance in inches Measurement B.

Sep 01, While standing away from the tree, at a position 90 degrees to the direction of fall, sight up to the top of the tree using a weighted string or an axe as a plumb and note the location on the ground.

The back lean is the distance from this point along the intended direction of fall to. Felling Mechanics Height Of Holding Wood -- Stump Shot Or Anti-kickback Device (Perform Experiment) – Prevents Kickback From Tree Rotating About Its Center Of Mass – Prevents Kickback When Striking Another Tree In Standing Timber Width Of Holding Wood –Tree Hinged To The Stump While Falling – Controls The Direction And Fall Of The Tree – Without Holding Wood The Tree Is.

Apr 19, Wedge 'stacking' techniques seems like the best bet to me, where plunge cuts are made into the trunk at about 2" intervals at perpendicular angles to the hinge. 2 or 3 is usually adequate.

The wedge is used to drive the tree over.

Slide the wedges in and hammer away for some serious lift. Estimated Reading Time: 10 mins.